Re: 2.2.18 version cant login at start

From: "john huttley" <john@mwk.co.nz>
Subject: Re: 2.2.18 version cant login at start
Date: Sat, 6 Jan 2001 21:18:38 +1300

Next Article (by Date): Re: Upcoming 1.1.1 changes "john huttley"
Previous Article (by Date): v1.1.1-pre1 Amon Ott
Top of Thread: 2.2.18 version cant login at start "john huttley"
Next in Thread: Re: 2.2.18 version cant login at start Amon Ott
Articles sorted by: [Date] [Author] [Subject]

Its still there. I see it on two systems, one UP the other SMP.
Both running RH7. The rsbac_auth_enable_login doesn't help.

maintenance kernel has same problem.

RH7 has many good things, but sometimes you wonder...

I'm not too concerned. Now that 2.4 is out I'm concentrating on that.

Regards

> On Mon, 01 Jan 2001 john huttley wrote:
> > On a clean RH7 system I set rsbac up with  the 2.2.18 kernel and built a
> > maintenance kernel.
> >
> > It looks ok until I login, then on prompting for a password it scrolls
the
> > password prompt very fast.
> >
> > If I then change to another VC I get messages like
> >
> > init must be supervisor
> >
> > or 'Go away, you dont exist'
> >
> >
> >
> >
> > Another system I've worked on is running test12 and it did not have this
> > problem.
> >
> > Any ideas??
>
> Did you use kernel parameter rsbac_auth_enable_login at first boot? Does
the
> problem still exist? I cannot see it here, but I have no RH7 package (and
no
> time to install and test it).
>
> Amon.
> -
> To unsubscribe from the rsbac list, send a mail to
> majordomo@rsbac.org with
> unsubscribe rsbac
> as single line in the body.
>

-
To unsubscribe from the rsbac list, send a mail to
majordomo@rsbac.org with
unsubscribe rsbac
as single line in the body.

Go to Compuniverse LWGate Home Page.